Setting up a Gen 1 wireless connection (MP-70/50 Only)

• Related Articles

• Setting up a Gen3 receiver with MP-73 or MP-53

  As with all wireless technology a receiver needs to be tuned to the correct frequency or band to receive a wireless signal from a specific transmitter. For our Generation 3 wireless radio's and controllers it's no different. Step 1: Get the ...

• What is G3 Wireless?

  The MP-73/53 Wireless G3 Option is the upgrade and replacement for the MP-70/50 Wireless Option and the MP-72/52 Wireless G2 Option. The MP-73/53 Wireless G3 Option uses the similar Spread Spectrum technology as the MP-72/52 but it uses a different ...

• Why isn't my wireless control connecting to the scoreboard?

  Check group/channel number on the scoreboard and control to be sure they are on the same number. To check the scoreboard, power down the scoreboard for 20 seconds then turn power back on. The number that displays in the home or visitor score window ...

• How to setup a scoreboard with an MP-80 controller.

  How to Set Up a Scoreboard with an MP-80 Controller To properly configure your scoreboard, you will need two pieces of information: Board Type: This is a two-digit code programmed into both the scoreboard and controller. You can identify your board ...

• MP-70/50 Programming Codes and Set Up

  If you have recently purchased a new MP53/MP73 scoreboard, it is important to follow certain steps to ensure that it is properly set up for use. This guide will walk you through the process of factory resetting and setting up your scoreboard. Factory ...