How do I change the group number on my scoreboard?
How do I change the group number on my scoreboard?
MP-80
Press Menu.
Press More twice.
Select Equipment Setup.
Select Wireless.
Select Scoreboard.
Select Group Number.
Enter the
new group for the scoreboard on the keypad and
press ENTER.
The Scoreboard ID will show on the scoreboard or boards.
Once all scoreboards have been identified,
enter the scoreboard ID number of the board on the
keypad and press ENTER.
MP-70/50 Series
Hold down the SHIFT and BAT/RF buttons until "Enter Pass Code" appears on the display.
Enter "7456" on the keypad.
Enter desired group number. (Note: This can be found in the control user manual.)
After the scoreboard resets (all 8's will flash on screen), a number will appear on the scoreboard; this number identifies the board in situations where multiple boards are on the same group or channel.
The group number is important to the operation of the controller, it determines the RF channel used by the controller to communicate with the scoreboard. By setting the group number, you ensure that the controller is communicating on the correct ...
How to Set Up a Scoreboard with an MP-80 Controller To properly configure your scoreboard, you will need two pieces of information: Board Type: This is a two-digit code programmed into both the scoreboard and controller. You can identify your board ...
The model number and sales order are found on the ID Label located on the right side of the scoreboard. Note: The model number is cross‐referenced in the control user manual to a board type. The board type is then programmed into the control to run ...
Verify that the control is operating properly. Check power at the control. Check data cable — cable, plug and connectors. Verify that the control is programmed for the correct sport or scoreboard type. Refer to the control user manual for ...